The design of this box and handle is intended to allow people with grasping difficulties to print small storage boxes tailored to their needs. They can also 3D print a handle that adapts to their abilities and allows them to comfortably access and open the boxes.
This set of parts allows you to make a support for a Tablet and place a visual tracking device if necessary. It is not a design suitable for use in a wheelchair or for those people who, having less motor control, hit the surface of the Tablet.
To completely assemble this device, two aluminum tubes and different screws are necessary, which are not included if you request printing the product
This design has been possible thanks to the collaboration of the association Móstoles Makers.
The objective was to design and manufacture a low-cost joystick to access the functions of a computer mouse.
The materials used in this development do not exceed €25.
Cap designed for Font Vella brand bottles whose objective is to reduce the flow of water and thus facilitate its intake for those people who need less flow to avoid choking.
The design of this piece is designed to be able to charge a mobile phone or a tablet using the batteries of the electronic chair itself, since practically all of them use the same type of connector as a charging port.
In this way, electronic wheelchair users will always have a charger for their devices on hand.
This design is not parameterizable.
The design of this piece is designed to be able to extend the table while raising or lowering it a few centimeters for those people who for various reasons are not able to reach the table correctly due to height problems.
It has been designed so that its attachment to the table is as simple as fitting it into the edge of the table, so that both its placement and removal from it can be done very easily and in just a few seconds.
The purpose of the piece is to be able to rest something on it, and it should not be used in any case as a support system when sitting and/or getting up from the table, since it is only designed to support a small weight, and not the load of a whole body.
